11 22 513 Replacing Roller Bearing For Dual-Mass Flywheel

Special tools required:

Necessary preliminary tasks:

Pressing out roller bearing:

Install special tool 23 4 031 in front of drive shaft spline teeth.

Screw in grease spindle 23 4 033 completely.

Brass tip must immerse fully into roller bearing.

Press in grease with grease gun 23 4 040 until roller bearing is disengaged from drive shaft. See 23 4 040 GREASE GUN

Fig 1: Identifying Special Tool (23 4 031) On Front Of Drive Shaft Spline Teeth

Courtesy of BMW OF NORTH AMERICA, INC.

Remove special tool 23 4 031.

Remove pressed-in grease (1) from drive shaft completely.

Then reinstall special tool.

Fig 2: Identifying Special Tool (23 4 031)

Courtesy of BMW OF NORTH AMERICA, INC.

Pressing in roller bearing:

Slide in pressure spindle 23 4 035.

Attach thrust piece 23 4 036 to pressure spindle.

Push roller bearing (1) onto thrust piece.

Fig 3: Pushing Roller Bearing Onto Thrust Piece

Courtesy of BMW OF NORTH AMERICA, INC.

Screw in pressure spindle (1) until roller bearing is fully pressed in.

Fig 4: Identifying Pressure Spindle

Courtesy of BMW OF NORTH AMERICA, INC.