51 43 201 Removing and installing or replacing trim for roof pillar at front (A-pillar), left or right

WARNING: Follow Safety Instructions for working on vehicles with airbag systems.

IMPORTANT: Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).

Unclip protective cap (1) with special tool 00 9 340 and remove.

Fig 1: Protective Cap And Special Tool (00 9 340)

Courtesy of BMW OF NORTH AMERICA, INC.

Detach mucket (1) in area of trim (2).

Unscrew bolt (3).

For tightening torque refer to 51 43 1AZ in 51 43 SIDE TRIM PANEL WITH ARMRESTS .

Unclip panel (2) at fastening points (4).

Feed out panel (2) from instrument panel (5) and remove.

Fig 2: Mucket, Trim, Bolt, Fastening Point, Instrument Panel And Removal Directions

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, lever out clips (1) remaining in bore.

If necessary, replace faulty clips (1).

Make sure guides (3) of panel (2) are correctly seated in associated mountings.

Position panel (2) pre-installed with clips (1) on associated bores and clip in to place.

Fig 3: Clips, Guides And Panel

Courtesy of BMW OF NORTH AMERICA, INC.