51 49 000 Removing and installing/replacing panel for rear lid (coupe)

Version with emergency release: 

Detach handle (1) from clip (2).

Disconnect Bowden cable (3) from handle (1).

Installation: 

Guide Bowden cable (3) through clip (2) and connect correctly in handle (1).

Fig 1: Handle, Clip And Bowden Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Release clips (1) and remove panel (2).

Installation: 

If necessary, replace damaged clips (1).

Fig 2: Clips And Panel

Courtesy of BMW OF NORTH AMERICA, INC.