51 47 490 Removing and installing / replacing front assembly underside protection

NOTE: Illustration created using E87 120i as an example. There may be differences in detail in the case of other models.

Release screws (1).

Pull underbody protection (2) forward under bumper trim (3).

Installation:

Centre underbody protection (2) and tighten down screws (1).

Fig 1: Underbody Protection, Bumper Trim, Screws And Removal Direction

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Fig 2: Underbody Protection Front Section

Courtesy of BMW OF NORTH AMERICA, INC.