67 11 555 Removing and installing / replacing servodrive for tank filler flap (coupe)

Necessary preliminary tasks:

Remove Top Trim From Tail Panel
Partially remove Luggage Compartment Wheel Arch Trim On Right

Feed out emergency actuation pull strap (1) in direction of arrow.

Fold acoustic insulation (2) forwards.

Fig 1: Identifying Strap, Strap Removal Direction And Acoustic Insulation

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Slacken screws (2)

Feed servodrive for fuel filler flap (3) in direction of arrow out of retaining plate (4) and remove.

Installation:

Carry out adjustment of servodrive for tank filler flap (3) via both elongated holes. It must be possible to lock or unlock the fuel filler flap completely.

Fig 2: Identifying Plug Connection, Screws, Retaining Plate And Fuel Filler Flap

Courtesy of BMW OF NORTH AMERICA, INC.

Turn sleeve (1) with a suitable tool (e.g.: pointed pliers) approx. 45° in direction of arrow and pull out of cover housing (2).

Fig 3: Identifying Cover Housing, Sleeve And Removal Direction

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Slide sleeve (1) over locking pin (2).

Make sure sleeve (1) is correctly engaged in cover housing (3).

Fig 4: Identifying Cover Housing, Sleeve And Locking Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release screws (1).

Disengage emergency actuation pull strap (2) from retainer (5) and remove towards front.

If necessary, unclip locking pin (3) in direction of arrow from servodrive for tank filler flap (4).

Fig 5: Identifying Locking Pin, Screws, Strap, Retainer And Filler Flap

Courtesy of BMW OF NORTH AMERICA, INC.