63 21 180 Removing and installing/replacing left or right rear light (in side panel) (coupe)

Remove cover (1) in direction of arrow from luggage compartment wheel arch trim (2).

Fig 1: Identifying Cover, Luggage Compartment Wheel Arch Trim And Removal Direction

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Unlock locking clip (2) in direction of arrow and remove socket housing (3) from rear light.

Fig 2: Identifying Locking Clip, Plug Connection, Socket Housing And Removal Direction

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (1), for tightening torque refer to 63 21 1AZ in 63 21 REAR LIGHT UNIT .

Remove spacer (2).

Release nuts (3), for tightening torque refer to 63 21 1AZ in 63 21 REAR LIGHT UNIT .

Remove rear light (4) in outwards direction from side panel (5).

Installation:

Make sure gap is uniform all round between rear light (4) and side panel (5).

Observe tightening sequence, first inside then outside.

Fig 3: Identifying Rear Light, Nuts, Spacer And Side Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure seal (1) is correctly seated on rear light (2).

Fig 4: Identifying Seal And Rear Light

Courtesy of BMW OF NORTH AMERICA, INC.