51 24 131 Removing and installing/replacing left or right striker for rear lid lock (convertible)

Necessary preliminary tasks: 

• Remove trim on support tube: 

  Release clips (1).

  Feed out panel (2) in direction of arrow.

  Installation: 

  If necessary, replace faulty clips (1).

  Fig 1: Identifying Feed Out Panel And Clips

  Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove shims (2) and striker (3).

Tightening torque: 10 Nm

Installation: 

Adjust STRIKER .

Fig 2: Checking Alignment Of Rear Lid And Striker

Courtesy of BMW OF NORTH AMERICA, INC.