51 24 004 Adjusting rear lid lock (convertible): Notes

Prerequisite: 

Rear lid must be correctly adjusted to fit; if necessary, adjust REAR LID .

For ideal adjustment, refer to BODY GAP DIMENSIONS .

Necessary preliminary tasks: 

• Remove trim for support tube: 

  Release clips (1).

  Feed out panel (2) in direction of arrow.

  Installation: 

  If necessary, replace faulty clips (1).

  Fig 1: Identifying Feed Out Panel And Clips

  Courtesy of BMW OF NORTH AMERICA, INC.

Slacken screws (1) until striker (3) can be moved.

Slide striker (3) in direction of arrow.

Tighten down screws (1).

Tightening torque: 10 Nm

Check alignment of rear lid and striker, readjust if necessary.

If necessary, remove shims (2) or insert additional.