51 23 110 Removing and installing/replacing left hood lock

Unclip coupling (1) from side panel.

Lever out cover (2) at coupling (1).

Lever cable (3) out of coupling (1).

NOTE: The operation "Disconnect cable for hood/bonnet locks" ends here.

Fig 1: Hood/Bonnet Lock Coupling, Cover And Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Fig 2: Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Carefully pull bumper (2) forwards and feed out hood/bonnet lock (3) with cable.

For tightening torque refer to 51 23 2AZ in 51 23 HOOD/BONNET LOCKS.

Fig 3: Screws, Bumper And Hood/Bonnet Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Disengage cable (1) from hood/bonnet lock (2).

When replacing cable for hood/bonnet locks:

Feed cable (1) out of front wall.

Fig 4: Cable And Hood/Bonnet Lock

Courtesy of BMW OF NORTH AMERICA, INC.