51 71 482 Removing and installing/replacing left or right trailing link (on rear axle) (up to 03/2007)

IMPORTANT: Observe SAFETY INSTRUCTIONS for raising the vehicle.
Driving without the tension strut is not permitted!

Release screws (1, 2, 3).

Remove tension strut (4).

Installation:

Replace screw (2).

Make sure screws are installed in correct positions.

Screw (1) M12x35
Tightening torque: see 25AZ in Fig 1.
Screw (2) M12x50
Tightening torque: see 26AZ in Fig 1.
Screw (3) M10x25
Tightening torque: see 20AZ in Fig 1.

Fig 1: Identifying Tension Strut And Screws
Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Left tensions strut (1) must be installed under right tension strut (2).

Fig 2: Identifying Left And Right Tension Strut Release Clips (1). Release Screws (2). Remove Underbody Cover (3).

Courtesy of BMW OF NORTH AMERICA, INC.