32 00... Moving vehicle into normal position
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Check compliance with Test Conditions , bring vehicle to a stop if necessary.
- Version with air spring system:
- Carry out ride-height-calibration
- Pull fuse(s) for air supply unit control unit
- Version with air spring system: Carry out ride-height-calibration
- Check vehicle interior and luggage compartment (incl. luggage compartment recess) for load, unload vehicle if necessary
- Introduce DIN load (refer to TECHNICAL DATA ) into vehicle
- Determine Vehicle Ride Height
NOTE:
If the vehicle ride height is not inside the tolerance (refer to TECHNICAL DATA
), the vehicle must be repaired (coil spring/leakage).