11 22 500 Removing and Installing or Replacing Flywheel (N54)
Special tools required:
- 11 4 180
- 11 9 260
Necessary preliminary tasks:
- Remove transmission.
- Remove clutch.
Enlarge special tool 11 9 260 with an elongated hole. (See 11 9 260 COUNTER SUPPORT WITH SCREW CONNECTION )
Work out elongated hole on special tool 11 9 260 to 8 mm . (See 11 9 260 COUNTER SUPPORT WITH SCREW CONNECTION )
Manual transmission:
Block flywheel with special tool 11 9 260. (See 11 9 260 COUNTER SUPPORT WITH SCREW CONNECTION )
Release flywheel screws with special tool 11 4 180. (See 11 4 180 SCREWDRIVER SOCKET TORX T60 )
Tightening torque, see 11 22 1AZ in ENGINE -- TORQUE SPECIFICATIONS -- TWIN TURBO
Installation:
Flywheel is secured with a dowel pin.
Fit new flywheel screws.
Automatic transmission:
Block flywheel with special tool 11 9 260. (See 11 9 260 COUNTER SUPPORT WITH SCREW CONNECTION )
Release flywheel bolts with tool (1).
Tightening torque, see 11 22 1AZ in ENGINE -- TORQUE SPECIFICATIONS -- TWIN TURBO
Installation:
Flywheel is secured with a dowel pin.
Fit new flywheel screws.
Assemble engine.