51 16 000 Removing and installing/replacing mirror on left or right front door
Unclip trim (1) from retaining clip (2) in inward direction.
Slide trim (1) upwards slightly out of guide (3) and remove.
NOTE:
On version with speaker, trim (1) can remain hanging over door trim panel.
Installation:
Retaining clip (2) must be fitted on door.
Installation:
Following parts of trim must not be damaged or missing:
- Sound insulation
- Retaining lug
- Guide
IMPORTANT:
Secure door mirror against falling down.
Disconnect plug connection (1).
Fold seal (2) to one side slightly and release screws (3).
For tightening torque refer to 51 16 1AZ .
Installation:
Rubber grommet for plug connection (1) must be correctly seated on door.
Seal (2) must be correctly seated on door trim panel and door.
Remove mirror (1) outwards.
Installation:
Check function.
Replacement:
- Modify Mirror Glass , replace if necessary
- Modify Cover Cap , replace if necessary