67 62... Notes on initializing power window unit in front door (coupe)

WARNING: Danger of injury!

There is no anti-trapping protection during initialization.

Rear power window unit does not have one-touch control function or anti-trapping protection and therefore does not require initialization.

Initialization is performed on the power window switch of the relevant door.

Requirements for correct initialization:

Initialization comprises:

An initialization must be performed:

In the event of malfunctions, e.g. no one-touch control function, no opening or if available no comfort function is possible
After the power window drive has been replaced
After work is carried out on the power window mechanism
If necessary, after a power supply interruption, e.g. disconnection of the battery or disconnection of the power supply to the door
After the door window glass has been removed and installed or replaced
After adjustment work on the door window glass
After adjustment work on the convertible top
After replacement of seals

Erasure of initialization:

Open door window glass fully
Actuate power window switch in "Open" position (second switch position) and hold down for between 15 and 20 seconds

This erases initialization of the power window, anti-trapping protection and toll function are inactive.

Check whether one-touch control (toll) function is inactive, otherwise repeat procedure.

Reinitialization:

Close door window completely
Once the upper end position has been reached, hold power window switch in "Close" position (second switch stage) for approx. 2 seconds longer

This completes initialization.

NOTE: Carry out function check (one-touch control function, anti-trapping protection and, if necessary, comfort function).