51 43 034 Removing and installing/replacing rear left or right lower side trim section (convertible): Notes

Necessary preliminary tasks: 

• Remove SIDE TRIM UPPER SECTION 
• Remove DECORATIVE STRIP FROM SIDE TRIM PANEL 
• Remove REAR SEAT .

Release screws (1).

Release lower side trim section (2) at clips (3).

Feed lower side trim section (2) out of entrance cover strip (4).

Disconnect all associated plug connections/cable holders and remove lower side trim section (2) in inward direction.

Installation: 

If necessary, replace faulty clips (1 and 2).

Fit all clips (1) with sealing ring.

Make sure clips (1 and 2) are in correct installation position.

1. White clip
2. Blue clip
   Fig 2: Identifying Sealing Ring Clips

   Courtesy of BMW OF NORTH AMERICA, INC.