51 46 026 Removing and installing or replacing front air outlet trim grille (convertible): Notes

Necessary preliminary tasks: 

• Remove TRIM COVER ON REAR LEFT/RIGHT ROLLOVER PROTECTION SYSTEM .
• Remove UPPER SECTION OF SIDE TRIM PANEL, LEFT/RIGHT .
• Tilt backrest forwards.
• Open lid for retractable hardtop, fold in retractable hardtop if necessary

Lift trim cover (1) out of retainers (2) with special tool 00 9 323 (scraper) and feed out towards rear.

Installation: 

Catches (2) on trim (1) must not be damaged.

Unclip trim cover (1) on left/right forwards.

Pull off cover (1) downwards.

Lever out covers (2) and release screws underneath.

Tightening torque: 8 Nm

Release clips (1).

Release screws (2).

Tightening torque: 8 Nm

Remove seat belts (3) from trim grille (4).

Detach trim grille (4) by lifting upwards.

Installation: 

Remove all screws/clips on trim grille (4).

Align trim grille (4) with rollover protection system and secure screws/clips.