Necessary preliminary tasks

• Remove INSTRUMENT PANEL TRIM , bottom right

Release screws (1) and remove counter-support (2).

Installation: 

Align glove box and screw down counter-support (2).

Check gap dimensions and closing comfort of glove box, realign if necessary.

Fig 1: Identifying Counter Support And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release clip (1).

Remove glove box (2) in inward direction.

If necessary, disconnect plug-in contacts.

Fig 2: Removing Glove Box

Courtesy of BMW OF NORTH AMERICA, INC.