61 61 100 Removing and installing/replacing both windscreen wiper arms

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2008 BMW 335xi, 2008 BMW 335i, 2008 BMW 328xi, 2008 BMW 328i, and 2007 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

61 6 210

Take off cap.

Fig 1: Identifying Windscreen Wiper Arm Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten nut.

For tightening torque refer to 61 61 11AZ in 61 61 WINDSCREEN WIPERS .

Fig 2: Identifying Windscreen Wiper Arm Mounting Nut

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Do not bend windscreen wiper arm during removal (risk of breakage).

Detach windshield wiper arm with special tool 61 6 210.

Fig 3: Identifying Special Tool (61 6 210)

Courtesy of BMW OF NORTH AMERICA, INC.

Adjust position of wiper arm in question in rest position (measured between wiper lip and top edge of cowl panel cover).

Then tighten down wiper arm and check adjustment dimensions of relevant wiper arm again.

Reference points (A, B) are the mountings of the wiper blades on the wiper arms to the sealing lip (1) of the cowl panel.

Contact angle (C) is the angle between wiper blade centre plane (2) and windscreen.

For tightening torque refer to 61 61 11AZ in 61 61 WINDSCREEN WIPERS .

Fig 4: Identifying Distance Between Windscreen Wiper Blade And Trim Panel On Cowl Panel

Courtesy of BMW OF NORTH AMERICA, INC.