11 61 050 Removing and installing intake air manifold (N52)

Necessary preliminary tasks:

Open holder (2).

Disconnect plug connection (1) under manifold.

Release both crankcase breathers (3).

Fig 1: Identifying Plug Connection, Crankcase Breathers And Holders

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Disconnect plug connection (3).

Release screws (4).

Detach engine wiring harness (2) from manifold and lay to one side.

Fig 2: Identifying Plug Connection And Engine Wiring Harness

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) on oil pressure switch.

Fig 3: Identifying Plug Connections, Wiring Harness And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release fuel rail (2) and lay to one side.

NOTE: Do not detach fuel line.

Release screw (1).

Unscrew nuts (3).

For tightening torque refer to 11 61 1AZ in 11 61 INTAKE MANIFOLD (N52) .

Fig 4: Identifying Fuel Rail And Mounting

Courtesy of BMW OF NORTH AMERICA, INC.

Raise intake manifold approx. 10 cm.

Disconnect plug connection (1) at bottom.

Release tank vent line behind throttle valve assembly.

Fig 5: Identifying Plug Connection At Bottom

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace all seals.

Assemble engine.