12 14 Electronic Shift Units or Control Units
ELECTRONIC SHIFT UNITS OR CONTROL UNITS TIGHTENING SPECIFICATION
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Knock sensor | N52, N52K, N51, N53 | M8x31 | Replace screws | |
| Jointing torque | 10 Nm | |||
| Torque angle | 90 ° | |||
| 2AZ Pulse generator for crankshaft | N52, N52K, N51, N53 | M6x16 | Replace screws | |
| Jointing torque | 3 Nm | |||
| Torque angle | 45° | |||
| 3AZ Pulse generator for inlet camshaft | N52, N52K, N51, N53 | M6x16 | 9 Nm | |
| 4AZ Pulse generator for exhaust camshaft | N52, N52K, N51, N53 | M6x16 | 9 Nm |