51 43 030 Removing and installing/replacing cover on front left or right rollover protection bar

Remove cover on rear rollover protection bar.

On version with wind deflector, lever out plugs (1) with needle and release screws underneath. Take off holder (2).

Installation: Replace plugs (1).

Fig 1: Removing Holder (2)

Courtesy of BMW OF NORTH AMERICA, INC.

Release catches (2) and remove cover (1) in direction of arrow. Installation: Fit cover (1) correctly in intermediate rings (3).

Fig 2: Removing Cover In Direction Of Arrow

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: Ensure catches (1) on cover (2) are not damaged.

Fig 3: Identifying Catches (1) On Cover (2)

Courtesy of BMW OF NORTH AMERICA, INC.