12 13 511 Replacing ignition coil (N62)

Switch off ignition.

Remove engine cover.

Pull ignition coil covers (1) out of rubber grommets.

Fig 1: Removing Ignition Coil Covers

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug fastener (1) of ignition coil.

Fig 2: Disconnecting Plug Fastener Of Ignition Coil

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug.

Pull out ignition coil (2).

This procedure is applicable to all ignition coils.

Fig 3: Removing Ignition Coil

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Fig 4: Inserting Rubber Seal On Ignition Coils

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Interrogate fault memory of DME control unit.
Check stored fault messages.
Rectify faults.
Now clear the fault memory.