51 71 412 Removing And Installing Rear Spoiler

Lever out covers (1) on left/right and release screw underneath.

Fig 1: Removing Rear Spoiler

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (2) on left/right and screw (3).

Remove rear spoiler and set down on a clean surface.

Installation:

If necessary, make a note of number of shims on screws (2) and (3) and refit them during installation at same position.

Tighten screw (3) first.

Tightening torque 51 71 2AZ. Refer to BODY EQUIPMENT - TIGHTENING TORQUES .

Installation:

Threads (1) on rear spoiler (3) must not be damaged.

Fig 2: Replacing Faulty Tapes (Dual-Lock Tape)

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, replace faulty tapes (2) (dual-lock tape).