LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2006 >> X5 48i >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body Equipment - Repair >> Trim, Covers, Handle Trim >> 51 13 403 Replacing handle strip (on trunk lid)

51 13 403 Replacing handle strip (on trunk lid)

Special tools required: 

Necessary preliminary tasks: 

Difference between versions before and after 09/01: 

Fig 1: Identifying Handle Strip Differences
G03268096Courtesy of BMW OF NORTH AMERICA, INC.

Lever light strip (1) on left/right out of recess (2) and remove.

Fig 2: Removing Light Strip
G03268097Courtesy of BMW OF NORTH AMERICA, INC.

Detach bulb (3) on left/right.

Installation: 

Perform function check with trunk lid open.

NOTE: Scope of work for "Replacing handle strip (on rear lid after 09/01)" ends here.

Handle strip after 09/01 on rear lid before 09/01: 

Use repair kit.

Fit new (closed) expansion nuts (1).

Fig 3: Pulling Off Film
G03268098Courtesy of BMW OF NORTH AMERICA, INC.

Clean area of handle strip (grease -free).

Pull off round film (2) from liner (4) and seal left bore hole.

Pull off long film (3) from liner (4), seal right bore hole and both elongated holes.

The liner is the protective film on the bonding area.

Attach seal (1) over plug connection (2) of new handle strip (3).

Fig 4: Attaching Seal
G03268099Courtesy of BMW OF NORTH AMERICA, INC.

Seal (4) must not be damaged.

Use only new screws (3.5 x 13 mm).

Installation: 

Perform function check with trunk lid open.

NOTE: Scope of work for "Replacing handle strip after 09/01 on rear lid before 09/01" ends here.

Version before 09/01 only: 

Detach seal (1) from handle strip (2).

Fig 5: Detaching Seal From Handle Strip
G03268100Courtesy of BMW OF NORTH AMERICA, INC.
NOTE: Do not damage trim (2) when removing catches (1).

Carefully lever panel (2) with special tool 00 9 322 (plastic wedge) out of handle strip (3) and remove.

Fig 6: Removing Panel
G03268101Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Catches (1) and guides (2) of trim (3) must not be damaged.

Fig 7: Identifying Guides Of Trim
G03268102Courtesy of BMW OF NORTH AMERICA, INC.

Remove adhesive residue (1) from handle strip (2).

Fig 8: Removing Adhesive Residue From Handle Strip
G03268103Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Perform function check with trunk lid open.