51 13 402 Removing And Installing Handle Strip (On Trunk Lid)

Difference between versions before and after 09/01:

Fig 1: Identifying Handle Strip Versions

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

In version (B), closed expansion nuts and shorter screws (3.5 x 13 mm) must be used.

Release screws (1) and withdraw handle strip (2) somewhat.

Fig 2: Releasing Screws Of Handle Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) and remove handle strip (2).

Fig 3: Removing Handle Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Seal(s) of handle strip (2) must not be damaged.

Tightening torque, 51 13 4AZ. Refer to BODY EQUIPMENT - TIGHTENING TORQUES .

Perform function check with trunk lid open.