11 51 000 Removing and installing complete water pump (M52 / S52 / M52TU / M54 / M56)

Remove alternator drive belt. Refer to 11 28 010 REPLACING ALTERNATOR DRIVE BELT (M52 / S52 / M52TU / M54 / M56) .

NOTE: M52 / S52
Water drain plug is located on exhaust side between cylinders 4 and 5 in engine block (illustration).
M52TU / M54 / M56
Water drain plug is located on exhaust side on cylinder 2 in engine block.

Fig 1: Locating Water Drain Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Drain and dispose of coolant.

Installation:

Replace seal.

Tightening torque 11 11 5AZ. Refer to ENGINE - TIGHTENING TORQUES .

Vent cooling system and check for leaks.

Release belt pulley.

Fig 2: Releasing Belt Pulley

Courtesy of BMW OF NORTH AMERICA, INC.

Release water pump.

Fig 3: Releasing Water Pump

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten two screws (M 6) into thread of water pump and water pump out of timing case.

Fig 4: Tightening Two Screws Into Thread Of Water Pump

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace O -ring and coat with coolant as anti-friction agent.

Fig 5: Locating O -Ring

Courtesy of BMW OF NORTH AMERICA, INC.