51 13 402 Removing and installing/replacing handle strip (on rear lid)

Necessary preliminary tasks:

Release catches (1 and 2) on handle strip (3).

Fig 1: Catches And Handle Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Feed handle strip (1) in direction of arrow out of rear finisher (2).

Fig 2: Handle Strip And Rear Finisher

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Seal (1) on handle strip (2) must not be damaged.

Replacement:

If necessary, replace seal (1).

Fig 3: Seal And Handle Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

If necessary, lever out license plate lights (1) at openings (2) in direction of arrow and remove from handle strip (3).

Fig 4: License Plate Lights And Handle Strip

Courtesy of BMW OF NORTH AMERICA, INC.