51 45 380 Removing and installing (replacing) right decorative strip on instrument panel
Necessary preliminary tasks:
Unscrew bolt (1).
Lever out right decorative strip on instrument panel (2) at retaining points (1) with special tool 00 9 317 .
Disconnect associated plug connection and remove right decorative strip on instrument panel (2).
Installation:
Clips (1) must be seated in associated mountings.
If necessary, remove clips (1) remaining on right decorative strip for instrument panel.
Replace damaged clips (1).
- Turn clip (1) with screwdriver to left by approx. 60°.
- Lever out clip (1) from below.
Replacement:
- Remove RIGHT FRESH-AIR GRILL .
- Remove CENTER FRESH-AIR GRILL .