51 24 050 Removing and installing/replacing lock element (lock cylinder) for rear lid

Necessary preliminary tasks:

Disconnect plug connection (1) on microswitch.

Detach Bowden cable (2) from holders.

Move lock actuator (3) in direction of arrow up to end stop.

Fig 1: Moving Lock Actuator In Direction Of Arrow Up To End Stop

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and turn complete lock (2) in direction of arrow.

Fig 2: Removing Screws And Turning Complete Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Turn lock (1) to right until guide (2) is located in metal cutout (3).

Remove lock in direction of arrow.

Fig 3: Removing Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Perform function check with trunk lid open.

Only replace:

Pull off rubber grommet (1).

Fig 4: Removing Rubber Grommet

Courtesy of BMW OF NORTH AMERICA, INC.