51 32 420 Removing and installing/replacing trim on front door window frame, left or right

Necessary preliminary tasks:

Partially detach rubber window seal (1) at rear.

Fig 1: Removing Window Cavity Cover Strip On Outside Of Front Door

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove finisher (2) and press approx. 3 mm towards rear.

Fig 2: Removing Finisher

Courtesy of BMW OF NORTH AMERICA, INC.

Remove finisher (1) towards top.

Fig 3: Removing Finisher Towards Top

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

All except Security version.

Following parts must not be damaged or missing:

1 Plastic nuts

2 Felt strip

3 Seal

Fig 4: Installing Plastic Nuts And Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Security version:

M5 pull-in nuts (1) must not be damaged or missing.

Trim is designed as a protective cover and is screwed into place with M5 X 20 mm stainless steel screws without shims.

Fig 5: Identifying Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check finisher (1) for damage, replace if necessary.

Fig 6: Checking Finisher For Damage

Courtesy of BMW OF NORTH AMERICA, INC.