51 11... Installing/replacing license plate (without base)

Initial fitting:

Place drilling hole template (1) on bumper (2).

NOTE: Hole diameter = 2.5 mm (see template).

Drill holes according to license plate.

Remove template (1).

Secure license plate with screws provided.

Installation:

Tightening torque: see 7AZ in 51 11 FRONT BUMPER .

Fig 1: Removing Template

Courtesy of BMW OF NORTH AMERICA, INC.

Fit protective caps.

Repairing thread:

Drill out defective hole in bumper (2) to 9.5 mm diameter.

Insert blind rivet nut (1).

Secure license plate (3) with license plate screw (M5 x 20).

Installation:

Tightening torque: see 8AZ in 51 11 FRONT BUMPER .

Fig 2: Inserting Blind Rivet Nut

Courtesy of BMW OF NORTH AMERICA, INC.