51 43 251 Removing And Installing/Replacing Trim For Rear Left Or Right Roof Pillar (Rear)
WARNING: This page is about a different car, the 2005 BMW 760Li, 2004 BMW 760i, 2004 BMW 760Li, and 2003 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Version with head airbag: Follow safety instructions for working on cars with airbag systems. Refer to 72 00... SAFETY REGULATIONS FOR HANDLING COMPONENTS WITH GAS GENERATORS
.
IMPORTANT:
Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).
Version With Head Airbag In Rear Compartment:
If necessary, lever out airbag emblem (1) and release screw underneath.
Tightening torque, refer to 51 43 1AZ in BODY EQUIPMENT - TIGHTENING TORQUES .
Release clips (2) and catches (4) from trim (3).
Pull out trim (3) towards inside at top.
Installation:
If necessary, replace defective grommets (1).
Installation:
Retainer (1) on trim (2) must not be damaged or missing.
Installation:
If necessary, replace faulty clips (1) of panel (3).
Catches (2) on trim (3) must not be damaged.