11 11 Engine Block, Cylinder Crankcase
ENGINE BLOCK, CYLINDER CRANKCASE B40 SPECIFICATION
| Bore diameter stage 0 a) | mm | 87.000 +0.014 |
| Bore diameter stage 1 a) | mm | 87.250 +0.014 |
| Bore diameter stage 2 a) | mm | 87.500 +0.014 |
| Permitted out-of-round of cylinder bore a) | mm | 0.007 |
| Permitted conicity of cylinder bore a) | mm | 0.01 |
| Permissible total wear tolerance between piston and cylinder (engine operated) | mm | 0.10 |
- new status or recondition
ENGINE BLOCK, CYLINDER CRANKCASE B48 SPECIFICATION
| Bore diameter stage 0 a) | mm | 93.000 +0.014 |
| Bore diameter stage 1 a) | mm | 93.250 +0.014 |
| Bore diameter stage 2 a) | mm | 93.500 +0.014 |
| Permitted out-of-round of cylinder bore a) | mm | 0.007 |
| Permitted conicity of cylinder bore a) | mm | 0.01 |
| Permissible total wear tolerance between piston and cylinder (engine operated) | mm | 0.10 |
- new status or recondition