31 10 010 Removing And Installing/Replacing Reinforcement Plate

Necessary preliminary tasks: 

• Remove underbody protective plate  . See REMOVING AND INSTALLING / REPLACING FRONT UNDERBODY PROTECTION  and REMOVING AND INSTALLING/REPLACING REAR UNDERBODY PROTECTION 

Release screws (1) and remove reinforcement plate.

Installation: 

Replace screws and insertion nuts.

Tightening torque 31 10 9AZ.  . See FRONT AXLE SUSPENSION .

Fig 1: Identifying Reinforcement Plate Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: 

If applicable, remove heat shield.