51 16 000 Removing and installing/replacing mirror on left or right front door (security)

Necessary preliminary tasks:

Pull off speaker (1) towards front and disconnect.

Fig 1: Identifying Speaker

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug-in connections (1) and (4).

Fig 2: Identifying Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (2).

Remove protective cover (1).

Feed out cable with mirror and remove.

Fabric adhesive tape (3)

Installation:

Replacement only:

Due to the thread-tapping screws, the tightening torque of the new mirror is increased by 2 Nm.

Fig 3: Identifying Screws And Protective Cover

Courtesy of BMW OF NORTH AMERICA, INC.

When replacing molded foam section:

Cut bead (1) and corner edge (2) with universal knife (see next two work steps).

Fig 4: Identifying Bead And Corner Edge

Courtesy of BMW OF NORTH AMERICA, INC.

Bead (1) cut.

Fig 5: Identifying Trimmed Bead

Courtesy of BMW OF NORTH AMERICA, INC.

Cut corner edge (1).

A = 5 mm

B = 18 mm

Fig 6: Identifying Corner Edge

Courtesy of BMW OF NORTH AMERICA, INC.

Corner edge (1) cut.

Fig 7: Identifying Trimmed Corner Edge

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts of mirror must not be damaged or missing:

Carry out function check of mirror and intercom system.