51 22 225 Removing and installing/replacing inside door opener of rear left or right door

Necessary preliminary tasks:

Unhook Bowden cable for release lever:

Installation:

For fitting, press release lever (1) fully onto door trim panel.

Fig 1: Identifying Bowden Cable, Lock And Release Lever

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: On initial installation there is no screw in area (A).

If necessary, release screw in area (A).

Release catches (1) and remove door opener (2).

Installation:

Fig 2: Identifying Screw Area, Catches And Door Opener (1 Of 2)

Courtesy of BMW OF NORTH AMERICA, INC.

Repair screw must be inserted in area (A) when door opener is installed.

Installation:

Catches (1) on door opener (2) must not be damaged.

Fig 3: Identifying Catches And Door Opener (2 Of 2)

Courtesy of BMW OF NORTH AMERICA, INC.