33 41 005 Replacing left drive flange on rear axle shaft
Special tools required:
- 33 2 116
- 33 2 160
- 33 2 201
- 33 4 200
Necessary preliminary tasks:
- Remove Output Shaft.
- Remove Brake Disk.
- Remove pulse generator.
Force drive flange with special tools 33 2 116 / 33 2 201, 33 2 160, 33 4 200 and 5 wheel studs out of wheel bearing.
NOTE:
Rounded inside edge of special tool 33 2 160 must point to drive flange.
IMPORTANT:
The wheel bearing is destroyed when the drive flange is removed and cannot be reused!
Replace Wheel Bearing.
Installation:
Install Output Shaft.
Oil drive flange lightly and attach to splines of output shaft.
Draw Drive Flange Into Wheel Bearing.
After installation:
- Adjust Handbrake