12 61 280 Removing and installing/replacing oil pressure sensor (N52, N52K, N51, N54, N53)

Necessary preliminary tasks: 

• Switch off ignition
• N52, N52K, N51, N53 only: 
  • Remove Ignition Coil Cover
• N54 only: 
  • Remove Intake Filter Housing

Installation location: 

Oil filter housing, front left.

Engine oil may emerge when oil pressure sensor is replaced; have a cleaning cloth ready.

Unlock plug (1) and remove.

Release oil pressure sensor (2).

For tightening torque refer to 12 61 1AZ in OIL PRESSURE - OIL TEMPERATURE .

Installation: 

Check engine oil level, top up engine oil if necessary.