65 11 080 Removing and installing/replacing radio receiver
IMPORTANT:
Read and comply with Notes On Protection Against Electrostatic Damage (ESD Protection)
.
Necessary preliminary tasks:
- Disconnect Battery Negative Lead
- Remove Operator Unit For Heater/Air Conditioner
NOTE:
Comply with Notes And Instructions On Handling Optical Waveguides
.
Release screws (1).
Pull back radio receiver (2) slightly.
Disconnect associated plug connections and remove radio receiver (2).
Installation:
Make sure the rear guide pin of the radio receiver (2) is correctly seated in the associated mounting.
Replacement:
Carry out programming/coding.