84 11 519 Removing and installing/replacing eject box

Special tools required:

Pull off gaiter (1) towards top.

Disconnect plug connection (2).

Fig 1: Disconnect Plug Connection

Snap out eject box (1) with special tool 00 9 340 on inner side of trim (2).

Pull eject box (1) on inner side upwards slightly.

Fig 2: Identifying Eject Box And Trim

Snap out eject box (1) with special tool 00 9 340 on outer side of trim (2).

Lift out eject box (1) and feed out cable.

Fig 3: Identifying Special Tool, Eject Box And Trim

Installation:

Catches (1) on trim (2) must not be damaged or missing.

Fig 4: Identifying Catches And Trim