41 5.... Front Side Doors Removal And Installation

IMPORTANT: Do not damage adjoining body parts.

The illustrations are schematic representations and are to be applied to the relevant vehicle type.

Open door.

Release screw on connector frame.

Front door:

For tightening torque refer to 41 51 4AZ.

Rear Door:

For tightening torque refer to 41 52 4AZ.

Fig 1: Locating Screw On Connector Frame

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Secure door against closing.

Release screw (1) on door retainer.

Front door:

For tightening torque refer to 51 21 3AZ.

Rear Door:

For tightening torque refer to 51 22 3AZ.

Fig 2: Identifying Door Retaining Screw

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Secure door against falling out.

Release screws between both hinge elements at top and bottom.

Pull both screws out of hinges.

Front door:

For tightening torque refer to 41 51 1AZ.

Rear Door:

For tightening torque refer to 41 52 1AZ.

Fig 3: Identifying Release Screws Between Hinge Elements

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out door sideways and place it on a suitable surface.

Fig 4: Removing Door Sideways

Courtesy of BMW OF NORTH AMERICA, INC.

Pull plug connection from door pillar, unlock by pulling out bar and detach.

Installation:

If necessary, Adjust Door .

Fig 5: Removing Plug Connection From Door Pillar

Courtesy of BMW OF NORTH AMERICA, INC.