LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2006 >> 325i Automatic >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Collision - Body Panel Repair (E90 & E91) >> 00 Body Panel Repair General Information >> 41 00... Workshop Equipment

41 00... Workshop Equipment

Minimum workshop equipment requirements in order to ensure the correct and expert performance of body repairs:

The tools listed below must be used  .

WORKSHOP EQUIPMENT CHART

  Steel Aluminum
Tool Structure Outer skin Structure Outer skin
Bodywork tool assortment x x    
Aluminum bodywork tool assortment     x x
Bodywork saw x x    
Single-handed grinder x x x x
Welding spot remover x x    
MAG welding apparatus x x    
MIG welding apparatus     x (E52 only)  
Spot welding apparatus x x    
Gas welder   x    
Straightening system x   x  
Stud welding apparatus     x  
Flame coating set     x  
Universal riveting tool     x  
IMPORTANT: In vehicles from model year 2001, higher-tensile and high-tensile steels are used in certain areas.

It is essential to check whether the spot-welding apparatus used conforms to the technical requirements of the currently recommended welding sets. Should you have any questions, please contact the country-specific Hotline.

The use of technically obsolete equipment may have serious consequences for the structure of the vehicle (e.g. in the event of a crash). In the end, this can result in safety and product liability risks which cannot be calculated.

Use and restrictions: 

Definition of Recommendation: 

All currently recommended spot welding sets comply with the requirements relating to reliable welding of today's  and future BMW Group vehicles. A spot welding unit will loose its recommendation as soon as tests with materials and material combinations designated for future use in BMW Group vehicles return negative results (see Table Group 1 ). All previous application before the withdrawal of the recommendation shall remain unaffected.

BMW RESTRICTIONS CHART

  Device designation Manufacturer
Group 1
Devices currently no  longer recommended
CR500 Car-O-Liner
Spot9000 Tecna
ATL 400V Wielnder&Schill
Group 2
Devices currently  recommended (March 2007)
MIDI spot QSVM9000 Celette
MIDI spot QSVM9000 Elmatech
CR600 Car-O-Liner
Multispot MI-100 Control Elektron

Application options and restrictions of above devices.

RESTRICTIONS DEVICES CHART

Vehicle Group 1 Group 2
E93 x
Except A-pillar, B-pillar, sill
x
E70 x
Except B-pillar
x
E64 x
Except A-pillar, B-pillar, sill
x
NOTE: (March 2007)

All models not listed can be repaired using the Group 1 and Group 2 devices.