51 23 100 Removing and installing/replacing right engine hood/bonnet lock

Necessary preliminary tasks:

Remove front intake duct

Unclip coupling (1) from side panel.

Lever out cover (2) at coupling (1).

Lever Bowden cable (3) out of coupling (1).

NOTE: The operation "Disconnect cable for hood/bonnet locks" ends here.

Fig 1: Identifying Coupling, Cover And Bowden Cable

G04728378

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Fig 2: Identifying Screws

G04728140

Courtesy of BMW OF NORTH AMERICA, INC.

Release Bowden cable (1) from holder (2).

Fig 3: Identifying Bowden Cable And Holder

G04728380

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

For tightening torque refer to 51 23 2AZ in 51 23 HOOD/BONNET LOCKS .

Carefully pull bumper (2) forwards and feed out hood/bonnet lock (3) with cable.

Fig 4: Identifying Screws, Bumper And Hood/Bonnet Lock

G04728381

Courtesy of BMW OF NORTH AMERICA, INC.

Disengage cable (1) from hood/bonnet lock (2).

When replacing cable for hood/bonnet locks:

Feed cable (1) out of front wall (3).

Fig 5: Identifying Front Wall, Cable And Hood/Bonnet Lock

G04728382

Courtesy of BMW OF NORTH AMERICA, INC.