65 77 740 Removing And Installing (Replacing) Left Front Door Sensor
WARNING:
Note airbag safety instructions! Incorrect handling can activate airbag and cause injury. Refer to 72 00 ... SAFETY REGULATIONS FOR HANDLING COMPONENTS WITH GAS GENERATORS
.
NOTE:
Follow instructions for handling optical fibres. Refer to 61 00 ... NOTES ON HANDLING OPTICAL FIBERS
.
Necessary Preliminary Tasks:
- Disconnect battery negative lead. Refer to 61 20 900 DISCONNECTING AND CONNECTING BATTERY .
- Remove control unit in left front door. Refer to 61 35 220 REMOVING AND INSTALLING (REPLACING) CONTROL UNIT FOR LEFT OR RIGHT FRONT DOOR .
Disconnect plug connection (1).
Release screws (2) and remove front door sensor (3).
Installation:
Make sure sensor is mounted without play.
Tightening torque, refer to 65 77 7AZ in AUDIO, NAVIGATION AND ANTI-THEFT - TIGHTENING TORQUES .
Installation:
Check seal (1), replace if necessary.
Make sure seal (1) for front door sensor is correctly seated.
Replacement only:
Carry out coding/programming. Refer to DIAGNOSIS PROGRAMMING/CODING .