Removal & installation

Remove rear brake discs. See BRAKE DISC (REAR) .
Disconnect return springs with brake spring pliers. See Fig 1.
Twist clamping pins with Special Tool (34 4 000) through 90 degrees and disconnect. See Fig 2. Remove brake shoes.
To install, reverse removal procedure. Note installation position of adjusting screws (1) and (2). See Fig 3. Figure shows right side; left side is mirror image. Coat threads of bushing (1) and screw (2) with grease.
Check recoil springs and replace, if necessary.
Adjust parking brake. See PARKING BRAKE under ADJUSTMENTS.

Fig 1: Locating Return Springs

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 2: Removing Parking Brake Shoes

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 3: Locating Adjusting Screws

Courtesy of BMW OF NORTH AMERICA, INC.