34 41 220 Removing and installing/replacing all handbrake shoes
For Special Tool identification, see BRAKES - SPECIAL TOOLS - 5-SERIES (E60) .
Special Tools Required:
- 32 1 030
- 34 4 000
Installation:
- Remove rear brake disc. Refer to 34 21 320 REMOVING AND INSTALLING OR REPLACING BOTH REAR BRAKE DISCS .
After completing tasks, adjust handbrake. Refer to 34 10 014 ADJUSTING HANDBRAKE .
Lock adjuster unit (ASZE).
Using special tool 32 1 030, press stop (2) of adjusting spring back to such an extent that retaining hook (3) engages in stop (2).
Disconnect return spring (1) with brake spring pliers.
Installation:
Check and if necessary replace return spring (1).
Figure illustrates right side: left side is mirror image of this.
Pay attention to installation position of adjustment screw (2).
Apply a thin coat of grease to bush and screw threads.
Disconnect return spring (1) with brake spring pliers.
Installation:
Check and if necessary replace return spring (1).
Turn clamping pins (1) with special tool 34 4 000 through 90° and disconnect.
Remove brake shoes (2).