51 12 810 Removing and installing / replacing deformation element on bumper carrier on left or right

Necessary Preliminary Tasks: 

• Remove carrier for rear bumper trim. Refer to 51 12 050 REMOVING AND INSTALLING / REPLACING CARRIER FOR REAR BUMPER TRIM .

Release screws (1).

Remove locator (2) straight towards rear.

Installation: 

Tightening torque, refer to 51 12 3AZ in BODY EQUIPMENT - TIGHTENING TORQUES - 545I (4.4L) E60 .

Fig 1: View Of Locator Retaining Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Foam seal (1) on locator (2) must not be damaged.

Fig 2: Identifying Foam Seal On Locator

Courtesy of BMW OF NORTH AMERICA, INC.