32 21 151 Replacing left or right tie rod

Necessary preliminary tasks: 

• Remove front wheel. See WHEEL AND TIRES - REPAIR INSTRUCTIONS .

After installation:

• Perform Chassis Alignment Check .
• Carry out Steering Angle Sensor Adjustment/Adjustment For Active Front Steering .

Release nut; if necessary, grip brace at Torx socket.

Remove tie rod end from swivel bearing.

Installation: 

Keep journal on tie rod end and bore hole in swivel bearing clean and free from grease.

Replace self-locking nut.

Tightening torque, see 32 21 3AZ in WHEEL & TIRES - TIGHTENING TORQUES .

Determine measurement (A) to simplify following adjustment of front axle.

Release clamping nut.

Screw off tie rod end; if necessary, grip tie rod with open-end wrench.

Installation: 

Check gaiter, replace if necessary.

Mount clamping ring (1).

Screw in tie rod end to measurement (A).

Tightening torque, see 32 21 5AZ in WHEEL & TIRES - TIGHTENING TORQUES .