61 31 006 Removing and installing (replacing) fixture for steering column stalk (up to 09/2005)
WARNING:
Move wheels into straight-ahead position and do not alter this position during the repair work.
IMPORTANT:
Read and comply with NOTES ON PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .
Necessary preliminary tasks:
- Remove TOP SECTION OF STEERING COLUMN CASING .
- If necessary, remove deformation element for steering column trim.
NOTE:
Follow instructions for HANDLING OPTICAL FIBRES .
Release screws (1).
Pull back fixture for steering column switch (2) in direction of arrow.
Disconnect plug connections behind and remove fixture for steering column stalk (2).
Replacement:
- Remove TRAVEL DIRECTION DIMMER SWITCH .
- Remove WINDSHIELD WIPER SWITCH .
- If necessary, remove CRUISE CONTROL SWITCH .
- Remove VOLUTE SPRING CASSETTE
Replacement:
- Carry out PROGRAMMING/CODING with BMW scan tool.
- Vehicles without active front steering:
- Carry out STEERING ANGLE SENSOR ADJUSTMENT
- Vehicles with active front steering:
- Carry out ACTIVE FRONT STEERING START-UP/ADJUSTMENT .