65 11 072 Removing and installing/replacing CD changer
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION)
.
Necessary preliminary tasks:
- Remove LUGGAGE COMPARTMENT TRIM ON SIDE PANEL ON RIGHT .
- Disconnect BATTERY NEGATIVE LEAD .
NOTE:
Comply with notes and instructions on HANDLING OPTICAL FIBERS
.
Open rotary clips (1) and remove.
Remove cover (2) in direction of arrow.
NOTE:
Open glovebox.
Fold back covers (1) on CD changer (3).
Release screws (2).
Pull back CD changer (3) slightly.
Unlock and disconnect associated plug connection, remove CD changer (3).
Installation:
Tightening torque: 0.7 Nm
Observe tightening torque (risk of damage).
Installation:
When pushing CD changer in, lay associated wire harness carefully by hand. For this purpose, in advance:
Remove BOTTOM RIGHT TRIM PANEL FROM INSTRUMENT PANEL .
Replacement:
Carry out PROGRAMMING/CODING .